2005 Park ProEdge 3
Hours on spindle 1500
$33k OBO
This is a Pro Edge III with just 1500 hours on it. The C-Arm, V-Rollers, hydraulic filter, hydraulic motor, and air filters are all good. All the attachments are in good shape. The table top is in good shape. The overall condition of the machine is like new. Includes some tooling, a Park bench, and a back splash jig.
Machine is up and running production.
Spindle:
2/2.5 HP, 1710/3420 RPM
Pneumatic head travel with position lock (with pressure gauge and adjustment); stroke length: 2î
Center water feed
Internal air purge system
Tool adapter to accept 100mm snail lock or 5/8-11 NC connections
Shape tool adapter
Spindle Miter:
0 to 189 degree miter range
Hydraulic rack and pinion drive
Hardened alloy-steel C-arm with powder-coated finish
Rise and Fall:
3î rise and fall travel
Round rail precision guide system
Manual positioning with pointer/ruler display
Cross Travel:
Hydraulic, 15-100 FPM variable speed
Heavy-duty rack and pinion drive system
Cross travel carried on two chrome hardened steel rails with slide bearings, automatically lubricated
Table and Clamping:
12íL x 4íW precision-machined tabletop work area with rubber matted surface
Pneumatic, pop-up, ìall wayî rollers to assist in positioning, loading and unloading stone (2,500 lbs. total lifting capacity)
Five adjustable, pneumatic hold downs with aluminum extension bars
Built-in storage for aluminum extension bars
Adjustable PARK bench to support long pieces
Construction:
Table: Heavy-duty structural steel/plate construction, stress relieved and precision machined
Bridge: Tubular bridge design, stress relieved and precision machined
Electrical and Plumbing Requirements:
Electrical power at machine: 240 volt (+/- 10%), 3 phase, 60 Hz, 30 amps required
Air at machine: 8 SCFM volume, 100 PSI pressure free of oil, water and grit larger than 25 micron (3/8î I.D. air line)
Water supply at machine: 5 GPM, 50 PSI, filtered to 5 micron (1/2î I.D. water line with clean, fresh water)
Capabilities:
A variety of convex edges (3/8î to 6î thick) and flat edges (3/8î to 4î thick) can be shaped and polished
A variety of concave edges can be shaped
Ogee edges can be shaped and polished
Shaping and polishing length: 1í to 12í long
Profile shaping and polishing thickness from 3/8î to 6î (spindle adjustment required on stone over 2-1/2î thick, must bevel corners on stone over 3î thick)
Radius capacity: 0î to 3î radius
ìAll wayî rubber pop-up roller system allows work pieces to be loaded and positioned easily without scratching or breaking
The top line can be controlled on all types of stone to achieve the profile blend that suits your needs
Bullnose edges, including laminates, are back gauged and polished, even past the bottom transition line
Uniform edges on each individual job
An 80% reduction in labor cost on lineal footage can be achieved
Unmatched setup time
Eliminates double-cutting of laminations
Compared to hand tools, abrasives cost per linear foot may be reduced by as much as 60%
Weight: 15,000 lbs.
Overall dimensions: 19í-2îL x 6îW x 8í-6îH
Floor space requirements: 23íL x 13íW x 8í6îH
Machine is located in Indiana
